This is a Front Brake disc conversion and lowering kit, It will lower your vehicle by approx 2.5" It is not like any other kit on the market
This kit comes built up ready to go straight on the Beetle, Even the wheel bearings have been greased.
What you get is 2 x Dropped spindle Stub axles, 2 x Brake discs, 2 x Brake calipers with brake pads and pad fitting kits, 2 x sets of wheel bearings with seals, 2 x Bearing washers, 2 x Bearing adjuster nuts, 2 x Bearing caps and all the bolts needed to put it all together.
We then assemble it all and grease the bearings, All you have to do is remove your drum set up and fit this little lot and you will have a lowered disc brake conversion on your Beetle, Dropped spindles are the best way to lower your vehicle because unlike other lowering methods you don't loose any of your suspension travel thus retaining your ride comfort and quality
****Please read the notes below ****
These will fit VW Beetle from 1964 to 1979 ( Ball joint axle models) they will not fit 1302 or 1303 Models
If fitting to vehicles before 1968 with 5 bolt wheels you will have to fit later style 4 bolt wheels or use a wheel adaptor kit, When fitting to vehicles before 1968 You will have to change the outer track rod ends to the large taper type. Please note Dropped spindle vehicles do not use back plates they also widen the track of the front wheels by 0.5 inch this may cause clearance problems on cars with wide alloy wheels
This is built with Quality parts.