This is a great lowering kit, you get a pair of good quality 75mm lowered front springs these will lower your front end by approximately 75mm

And a pair of good quality adjustable rear spring plates, They are designed to take all the hard work out of adjusting the height of your rear suspension, They must be used with 21 3/4 inch torsion bars. This length was fitted as standard to most late swing axle cars. If they are not fitted to your car they can be sourced from a donor vehicle or purchased. These will also require 2 inch inner torsion arm grommets and 1 7/8 inch outer's.

This kit will fit VW Beetle 1970 to 1979 all I.R.S models. (1302 & 1303 models)

This is the easiest and most cost effective way of lowering an IRS Beetle (1302 or 1303 Model )